HP 74 Black Ink Cartridge
- 1
Place paper towel on a table. Remove the ink cartridge from the printer carriage and place it on the paper towel. Remove the label from the cartridge.
- 2
Remove the syringe and bottle of ink from the refill kit. Insert the syringe needle into the bottle of ink. Draw out 20 milliliters of ink by pulling up on the plunger.
- 3
Place the tip of the needle into any of the vent holes on the cartridge as far as it will go without force. Press the syringe plunger to inject the ink slowly. If any ink bubbles out of the vent hole, stop filling and wipe with paper towel. Cartridges that are not empty will not take the full amount of ink.
- 4
Tape the cartridge where the label was. Place the filled HP 74 ink cartridge in the printer and run two to three test pages using any document.
HP 75 Color Ink Cartridge
- 1
Lay down paper towel. Remove the ink cartridge from the printer and place it on the towel. Remove the label from the color ink cartridge to reveal the refill holes. Remove the supplies from the kit. There are three syringes and bottles of cyan, magenta and yellow ink.
- 2
Insert one syringe into the cyan ink bottle. Pull up the plunger to draw 6 milliliters of ink into the syringe. Repeat this step using syringes for the magenta and yellow ink.
- 3
Insert the tip of the first needle into the corresponding ink color. Slowly push down on the syringe plunger to inject the ink into the HP 75 cartridge. If the ink bubbles out of the vent hole, stop filling and wipe with paper towel. Cartridges that are not empty will not take the full amount of ink. Repeat this step to fill the other two colors. Hint: Yellow is at the top center, magenta is at the bottom left and cyan is at the bottom right.
- 4
Tape the cartridge where the label was. Place the ink cartridge in the printer. Run two to three test pages using any document.
No comments:
Post a Comment