Removal Instructions for 1995 Infiniti G20 Drive Belts

The Infiniti G20 utilizes two drive belts. One turns the pulleys for the alternator and the A/C compressor and uses a separate idler pulley to maintain tension on the pulley system. The second belt runs all of the other accessories on the vehicle and is referred to as a serpentine belt. The serpentine belt uses an idler pulley located on the bottom of the engine. This pulley keeps tension on the serpentine belt to prevent it from squealing.

Alternator Drive Belt

• 1

  Locate the idler pulley between the alternator and the A/C compressor.

• 2

  Loosen the lock nut at the center of the idler pulley with an adjustable wrench.

• 3

  Push up on the pulley with your hand to loosen tension on the drive belt.

• 4

  Pull the drive belt off of the alternator and A/C compressor pulleys.

Serpentine Drive Belt

• 1

  Place a 3/8-inch ratchet driver into the square hole on the face of the idler pulley located next to the crankshaft pulley.

• 2

  Lift up on the handle of the ratchet driver to relieve tension on the serpentine belt.

• 3

  Lift the belt off of the idler pulley then remove the belt from the other pulleys.